Compliance and Regulatory Statements
1. EN55022 and CISPR22 – Class A warning
This is a Class A product that may cause radio interference. In this case, the user may be required to take
adequate measures.
2. FCC Part 15 Statement
This digital equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment generate,
use and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area are likely to cause harmful interference, in which case the user will be required to correct the interference
at his or her own expense.
3. FCC Part 68 Statement
This equipment, when equipped with the X100M or X400M module, complies with Part 68 of the FCC rules
and the requirement adopted by ACTA of the United States.
On the product nameplate of this equipment (located on the rear of the chassis) is a label that contains,
among other information, a product identifier in the format US: AAAEQ##TXXXX.
If requested, this number must be provided to the telephone company.
Connection to the Telephone Line
This equipment cannot be used on the public coin phone service provided by the telephone company.
Connection to party line service is subject to state tariffs.
Your telephone company may discontinue your service if your equipment causes harm to the telephone
network. They will notify you in advance of disconnection, if possible. During notification, you will be informed
of your right to file a complaint to the FCC.
Occasionally, your telephone company may make changes in its facilities, equipment, operation, or
procedures that could affect the operation of your equipment. If so, you will be given advance notice of the
change to give you an opportunity to maintain uninterrupted service.
The registration number of the system must be provided so that the telephone company can ascertain
intended modes of operation and verification of registration ports.
If a need arises in the future, the telephone company will call the user and request the following information for
any equipment being connected to the Public Switched Telephone Network:
• Manufacturer: Digium Inc.
• Model Number: Refer to the nameplate on the chassis
• Ringer Equivalence Number (REN): 0.1A
• Facility Interface Code (FIC): 02LS2
• Service Order Code (SOC): 9.0Y
• Universal Service Order Code (USOC): RJ11C
(75 paginas)
(130 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales